DEFCAR
 INTERFACES WITH OTHER SYSTEMS

If you have any other software like Autoship, Tribon, Maxsurf, Microstation, AutoCad, etc, that exports and/or imports DXF or IGES files you can use some modules of the Defcar system:

See the table below for a diagram of inputs/outputs.
 
Input
Module
Output
Templates
ShipGen
Automatic Hullform
Generation
Hullform in 
-Defcar Database  
-or IGES NURBS surfaces 
-or DXF 2D or 3D
You can start from: 
- Zero
- or Defcar Database
- or Points offset in DXF 
- or IGES NURBS surfaces
Dfform
Hullform design
Hullform in 
-Defcar Database 
-or IGES NURBS surfaces 
-or DXF 2D or 3D
-Defcar Database
-or IGES NURBS surfaces
-or lines plan in DXF 2D or 3D
Dfshell
Shell expansion
- Defcar Database
- or DXF 2D or 3D
-Defcar Database
-or lines plan in DXF 2D or 3D
Dfestruc
Structural steelwork
- Defcar Database
- or IGES 3D structural model
- or DXF 3D structural model
- or Pieces DXF 2D
- or ACIS files
-Defcar Database
-or pieces in DXF 2D
Lantek
Nesting and
NC cutting
- NC for cutting
- or Defcar Database
- or Nesting DXF 2D
 
 
 
Input
Module
Output
You can start from: 
- Defcar Database
- or Points offset in DXF 
- or IGES NURBS surfaces
Dfhidro
Naval architecture
Calculations
Results in:
- Printer
- ASCII files

Cintranaval-Defcar S.L.
Lauroeta Etorbidea, 4 48180 Loiu, Bizkaia (Spain)
Tlf: +34 902158081
Fax: +34 944638552
info@cintranaval-defcar.com